Every electronic device you own has one of these inside. A printed circuit board is a laminate sheet with copper traces etched into it, holes drilled for connections, and flat metal pads where components get soldered. The traces carry signals and power between parts. The board can be one layer, two, or many stacked together.
The sheet itself is an insulator. Most boards use FR-4, a flame-resistant mix of woven fibreglass and epoxy resin, with copper for the traces and planes. Extra metal and dielectric layers get laminated in as the layer count rises.
Board classes: how much failure can you afford
IPC classifies boards into three grades, and the grade decides how strict the inspection gets.
- Class 1 covers general consumer goods where a field failure is an annoyance.
- Class 2 covers equipment that has to work reliably for a long time. Most industrial and commercial products land here.
- Class 3 covers hardware where failure endangers lives: medical, aerospace, critical systems. Inspection is strictest and the paperwork follows every board.
Tell your supplier which class you need before quoting. It changes what gets inspected and what the build costs.
The three board constructions
Most boards you will meet are rigid: copper and FR-4 laminated under heat and pressure into a stiff sheet. They take standard SMT and through-hole assembly without special handling.
Flexible boards use a thin polyimide film instead of rigid laminate. They bend, fold and fit into tight or moving assemblies like wearables and camera modules. They need different handling on the line and different design rules for bend areas.
Metal-core boards bond the circuit to an aluminium or copper base that spreads heat. LED lighting and high-current power designs use them where a standard laminate would cook the components above it.
What your design tools need to get right
Fabrication and assembly both run off your files, so the files decide the outcome. Your CAD package needs clean library parts with correct footprints, trace routing that respects clearances for your voltage and spacing class, and a stack-up the fabricator can actually build. High-speed designs add impedance control and length matching to that list.
The most common file problems we see: footprints that do not match the actual part, silkscreen over pads, missing drill data, and a stack-up the board shop has to guess at. Each one stops the job while someone asks a question that the files should have answered. A short manufacturability review before ordering costs a day. Fixing these mid-build costs a week.