Yield at volume
At tens of thousands of units, a fraction of a percent of yield is real money. Our end-of-line defect rate is held below 0.2% with 100% AOI on every run.
Industry
Consumer electronics is a race on cost per unit and defect rate at the same time. A product that ships at scale has to be cheap to build and reliable enough that the returns do not eat the margin. Sanmitron builds consumer electronics for brands and distributors who need both.
What matters here
At tens of thousands of units, a fraction of a percent of yield is real money. Our end-of-line defect rate is held below 0.2% with 100% AOI on every run.
Four SMT lines running high-speed Panasonic CM602 mounters keep cycle time low, and DFM review removes cost before it is built in rather than negotiated out afterwards.
Box build is where consumer electronics lives or dies. We assemble against a golden sample so the finish is the same on unit 50,000 as it was on unit 50.
How we deliver it
Other industries
Control boards, power supplies and instrumentation that have to work for years, not seasons.
In-vehicle electronics where vibration, temperature and long life set the bar higher than consumer.
Healthcare electronics where clean assembly and complete documentation are the entry requirement.
Connected devices where radio performance, antenna tuning and low power design drive the build.
Network and connectivity equipment built for continuous duty and demanding thermal conditions.
Driver boards, controllers and lighting products where thermal and colour consistency decide the product.
Inverters, controllers and monitoring boards for high-power and high-voltage applications.
Get Started
Send your drawings, Gerbers or BOM. Our engineers review what you have and reply with what we can build, what we would change, and how long it takes. Guaranteed response within 24 hours.