Every PCB assembly supplier claims quality. Few will show you the numbers behind the claim. This guide covers what high-quality assembly actually depends on, which metrics to ask for, and how to verify them before your boards go into production.
Inspection coverage: the non-negotiable baseline
Inspection is where quality is proven, and coverage gaps are where defects escape. Ask for each of these explicitly:
- Solder paste inspection (SPI) after printing. It catches insufficient or bridged paste before components are placed, when the fix costs nothing.
- Automated optical inspection (AOI) after placement, on 100% of boards rather than a sample. Sampling plans let systematic defects through; full coverage catches them on the first board.
- X-ray inspection for hidden joints. BGA, QFN and similar packages cannot be optically inspected. Without X-ray, their solder quality is assumed, not verified.
- In-circuit and functional test recorded per unit. It verifies the assembly works, not only that it looks right.
Our lines run all four: SPI and 100% AOI on four Panasonic CM602 SMT lines, X-ray for hidden joints, and per-unit test records. End-of-line defect rate holds below 0.2%.
The numbers worth asking for
| Metric | What good looks like | Why it matters |
|---|---|---|
| End-of-line defect rate | Below 0.5%; below 0.2% is excellent | Direct measure of escaped defects |
| AOI coverage | 100% of boards | Sampling misses systematic issues |
| Test records | Per unit, retained | Without records, a failure in the field cannot be traced |
| Component traceability | Every lot verified against part number | No relabelling, no undocumented substitutions |
If a supplier cannot quote a defect rate, that absence is your answer. Nobody improves a metric they never track.
Component authenticity and solder quality
Two quality failures start before the board reaches the line. Counterfeit or substituted components (relabelled parts, wrong temperature grades, reclaimed chips) cause field failures that no inspection can fully catch, because the part itself is wrong. Prevention is incoming verification of every lot against the manufacturer part number, from authorised distributors or qualified partners, with substitutions never made without approval.
Solder quality is the second: voiding under thermal pads, insufficient wetting on leadless packages, tombstoning on small passives. These are process problems with process solutions: verified profiles, correct paste volume (which is why SPI matters), and X-ray confirmation on the packages optics cannot see.
Process discipline across volumes
A prototype and a production run should differ in quantity, never in quality. Prototypes built on separate bench lines with hand inspection tell you nothing about what volume production will yield. Our prototype builds run 15 days on the same production lines, with the same SPI, AOI and test as volume — so the quality data from ten boards predicts the quality of ten thousand.
Certifications frame the system but do not replace it: ISO 9001:2015 for the quality management process, BSCI and SEDEX/SMETA audits for the operating environment. Ask to see the certificates, then ask for the defect rate anyway. Certificates describe the system. The defect rate proves it works.
Audit questions for your supplier shortlist
- What is your end-of-line defect rate over the last 12 months?
- Is AOI 100% or sampling? Is X-ray available for BGA/QFN?
- Are test records retained per unit, and for how long?
- How is incoming component authenticity verified?
- Are prototypes built on production lines with production inspection?
- How are substitutions and obsolescence handled, and do I approve them first?
A supplier that answers all six with specifics is worth quoting. One that answers with adjectives is worth skipping.